Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW MASTER SWITCH (for Hatchback)

POWER WINDOW MASTER SWITCH (for Hatchback) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE DOOR ARMREST COVER


B116818
  1. for 5 Door:
    Using a screwdriver with its tip wrapped in protective tape, disengage the 8 claws and 3 clips and remove the door armrest cover.



    B116851
  1. for 3 Door:
    Disengage the 12 claws and 3 clips and remove the door armrest cover.



3. REMOVE FRONT ARMREST BASE PANEL UPPER


B116819
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws and clip and remove the front armrest base panel upper.

  1. Disconnect the connector.



4. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY


B118070E01
  1. Remove the 3 screws and the power window regulator master switch.