Home › BODY › WINDSHIELD / WINDOWGLASS › BACK DOOR GLASS (for Hatchback)

BACK DOOR GLASS (for Hatchback) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE CENTER STOP LIGHT COVER


E114436E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the 2 rear light covers.



    E107943
  1. Remove the 2 screws.



    E114437
  1. Disengage the 2 claws.

  1. Disconnect the connector and remove the center stop light cover.



3. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY


E107899
  1. Open the rear wiper arm head cap.



    E107900
  1. Remove the nut and rear wiper arm and blade.



4. REMOVE BACK DOOR GLASS


B116965E01
  1. Apply protective tape to the outer circumference of the back door glass, as shown in the illustration.

  1. From the interior, insert piano wires between the vehicle body and back door glass, as shown in the illustration.

  1. Tie objects that can serve as handles (for example, wooden blocks) to all wire ends.

    NOTICE:
    When separating the back door glass from the vehicle, do not damage the vehicle's paint or exterior/interior ornaments.

  1. Cut through the adhesive by pulling the piano wire around the back door glass.



    B116966E01
  1. Disengage the 2 clips.

  1. Using suction cups, remove the back door glass.

    NOTICE:
    Leave as much adhesive on the vehicle body as possible when removing the back door glass.