GENERATOR > INSTALLATION |
| 1. INSTALL GENERATOR ASSEMBLY |
![]() |
Provisionally install the generator with fixing bolt B.
![]() |
Provisionally install the fan belt adjusting slider with fan belt adjusting slider fixing bolts A and B, then move the generator toward the cylinder block and tighten bolt B.
![]() |
Install the connector and wire harness clamp.
Install terminal B with the nut.
Install the terminal cap.
Close the terminal cap.
| 2. INSTALL FAN & GENERATOR V BELT |
Provisionally install the fan and generator V belt onto each pulley.
| 3. ADJUST FAN & GENERATOR V BELT |
![]() |
for Unleaded Gasoline Specification Vehicle:
Insert an adjusting bar between the engine mounting bracket and generator assembly. Pull the adjusting bar towards the vehicle front to adjust the generator V belt tension.
![]() |
for Leaded Gasoline Specification Vehicle:
Insert the adjusting bar between the engine mounting bracket and generator assembly. Pull the adjusting bar towards the vehicle front to adjust the generator V belt tension.
![]() |
First tighten bolt A, then tighten bolt B.
| 4. INSPECT FAN & GENERATOR V BELT |
![]() |
Check the V belt deflection and tension.
| Item | Specified Condition |
| New belt | 8.0 to 9.0 mm (0.31 to 0.35 in) |
| Used belt | 12.5 to 13.5 mm (0.49 to 0.53 in) |
| Item | Specified Condition |
| New belt | 700 to 800 N (71 to 82 kg, 157 to 180 lb) |
| Used belt | 300 to 400 N (31 to 41 kg, 67 to 90 lb) |
| 5. INSTALL ENGINE UNDER COVER RH |
| 6. INSTALL ENGINE UNDER COVER SUB-ASSEMBLY (for Rough Road Area Specification Vehicles) |
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |