COOLING SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK COOLING SYSTEM FOR LEAKAGE |
![]() |
Fill the radiator assembly with engine coolant, then attach a radiator cap tester.
Pump the tester to 137 kPa (1.4 kgf/cm2, 19.9 psi), then check that the pressure does not drop.
If the pressure drops, check the hoses, radiator assembly and water pump assembly for leakage. If there are no signs or traces of external engine coolant leakage, check the heater core, cylinder block and head.
| 2. INSPECT RESERVOIR TANK ENGINE COOLANT LEVEL |
The engine coolant should be between the LOW and FULL lines when the engine is cold.
| 3. INSPECT ENGINE COOLANT QUALITY |
Remove the radiator cap sub-assembly.
Check for excessive deposits of rust or scale around the radiator cap sub-assembly and radiator filler hole. The engine coolant should be free of oil.
If excessively dirty, replace the engine coolant.
Reinstall the radiator cap sub-assembly.
| 4. INSPECT FINS FOR BLOCKAGE |
![]() |
If the fins are clogged, wash them with water or a steam cleaner and dry them with compressed air.
| Injection Pressure kPa (kgf*cm2, psi) | Injection Distance mm (in.) |
| 2942 to 4903 (30 to 50, 427 to 711) | 300 (11.811) |
| 4903 to 7845 (50 to 80, 711 to 1138) | 500 (19.685) |