COOLING FAN SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT COOLING FAN OPERATION AT LOW TEMPERATURES (Below 83°C (181°F)) |
Turn the ignition switch on (IG) and air conditioning switch off.
Check that the cooling fan stops.
If not, check the cooling fan relay and engine coolant temperature sensor, and check whether there is disconnection or an open circuit between them.
Disconnect the engine coolant temperature sensor connector.
Check that the cooling fan rotates.
If not, check the fuses, cooling fan relay, ECM and cooling fan, and check for a short circuit between the cooing fan relay and engine coolant temperature sensor.
Reconnect the engine coolant temperature sensor connector.
| 2. INSPECT COOLING FAN OPERATION AT HIGH TEMPERATURES (Above 93°C (199°F)) |
Start the engine and air conditioning switch off, and raise the engine coolant temperature to above 93°C (199°F).
Check that the cooling fan rotates.
If not, replace the engine coolant temperature sensor.
| 3. INSPECT COOLING FAN MOTOR |
Disconnect the cooling fan motor connector.
Connect the cooling fan connector to the battery and check that the fan motor moves smoothly.
![]() |
Using an ammeter, measure the amperage between the terminals.
Connect the cooling fan motor connector.