FUEL SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK FUEL PUMP OPERATION AND FUEL LEAKAGE |
When using the intelligent tester.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and intelligent tester main switch on.
Select the Active Test mode on the intelligent tester.
Check that there is no fuel leakage anywhere on the fuel system after doing maintenance.
| 2. CHECK FUEL PRESSURE |
Discharge the fuel system pressure (Click here).
Using a voltmeter, measure the battery voltage.
Disconnect the cable from the negative (-) battery terminal.
Remove fuel pipe clamp No.1 from the fuel tube connector.
Disconnect the fuel hose from the fuel main tube.
![]() |
Install SST (pressure gauge and fuel tube connector) as shown in the illustration.
Wipe off any split gasoline.
Reconnect the cable to the negative (-) battery terminal.
Connect the intelligent tester to the DLC3 (see step 1 in check fuel pump operation).
Measure the fuel pressure.
Disconnect the intelligent tester from the DLC3.
Start the engine.
Measure the fuel pressure while the engine idles.
Stop the engine.
Check that the fuel pressure remains as specified for 5 minutes after the engine stops.
After checking the fuel pressure, disconnect the cable from the negative (-) battery terminal and carefully remove SST to prevent gasoline splashes.
Reconnect the fuel tube to the fuel main tube.
Install fuel pipe clamp No. 1 to the fuel tube connector.
Check for fuel leakage (Step 1).