GENERATOR > INSPECTION |
| 1. INSPECT GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
Using vernier calipers, measure the exposed brush length.
| 2. INSPECT GENERATOR REGULATOR ASSEMBLY |
![]() |
Using an ohmmeter, check the continuity between terminals F and B.
![]() |
Using an ohmmeter, check the continuity between terminals F and E.
| 3. INSPECT GENERATOR DRIVE END FRAME |
![]() |
Check the stator coil for open circuits.
Using an ohmmeter, check the resistance between the coil leads.
![]() |
Inspect the stator for ground.
Using an ohmmeter, check the resistance between the coil lead and drive end frame.
Check the bearing.
Inspect the bearing is not rough or worn.
If necessary, replace the generator assembly.
| 4. INSPECT GENERATOR HOLDER WITH RECTIFIER |
![]() |
Using an ohmmeter, check the continuity among terminals P1, P2, P3 and B, and among P1, P2, P3 and E.
| 5. INSPECT GENERATOR ROTOR ASSEMBLY |
![]() |
Check the generator rotor for open circuits.
Using an ohmmeter, measure the resistance between the slip rings.
![]() |
Check the generator rotor for short circuits.
Using an ohmmeter, check the resistance between the slip ring and generator rotor assembly.
Inspect slip rings.
Make sure that the slip rings are not rough or scored.
If rough or scored, replace the generator rotor assembly.
![]() |
Using vernier calipers, measure the slip ring diameter.