Home › ENGINE ยท 2NZ-FE › CHARGING › GENERATOR

GENERATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR PULLEY


A193553E01
SST
09820-63011   (09820-06010, 09820-06021)
HINT 
SST 1-A and B
09820 - 06010
SST 2
09820 - 06021
  1. Clamp the generator housing stay in a vise.

  1. Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise to the specified torque.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }

    NOTICE:
    Check that SST is securely fitted onto the generator rotor shaft.



    A193554E01
  1. Insert SST 2, and attach the pulley nut to SST 2.



    A193555E01
  1. To loosen the generator pulley nut, turn SST 1-A in the direction shown in the illustration.

    NOTICE:
    To prevent damage to the rotor shaft, do not loosen the generator pulley nut by more than one half turn.

  1. Remove SST 2 from the generator.



    A193556E01
  1. Turn SST 1-B, and remove SST 1-A and B.

  1. Remove the generator pulley nut and generator pulley.



2. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


A117294
  1. Remove the nut and terminal insulator.

  1. Remove the nut, screw and rectifier plate.

  1. Remove the 2 nuts and the rear end cover.



    A117359
  1. Remove the brush cover from the generator brush holder assembly.

  1. Remove the 3 screws and the generator brush holder assembly.

  1. Remove the plate seal.



3. REMOVE GENERATOR REGULATOR ASSEMBLY


A117295
  1. Remove the 2 screws and the generator regulator assembly.



4. REMOVE GENERATOR HOLDER WITH RECTIFIER


A117360
  1. Remove the 3 screws and the generator rectifier holder.



5. REMOVE GENERATOR ROTOR ASSEMBLY


A117361
  1. Remove the 3 terminal insulators from the rectifier end frame.

  1. Remove the 4 nuts and the clip cord.



    A067420E01
  1. Using SST, remove the rectifier end frame.

    SST
    09286-46011  

  1. Remove the plate retainer.

  1. Remove the generator rotor assembly from the drive end frame.

    NOTICE:
    Do not drop the generator rotor assembly.

    HINT:
    If the generator rotor is engaged too firmly, gently tap the generator rotor shaft to remove it using a plastic hammer.