Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > Combination Meter ECU Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
Combination Meter ECU Communication Stop Mode
  1. "Combination Meter" not displayed on "Communication Bus Check" screen of intelligent tester
  2. Applies to "Combination Meter ECU Communication Stop Mode" in "DTC combination table"
  1. Power source circuit of combination meter ECU
  2. Combination meter ECU branch wire or connector
  3. Combination meter ECU

WIRING DIAGRAM


C118189E01


INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the CAN main wire and the CAN branch wire.
  2. After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

1.CHECK CAN BUS LINE FOR DISCONNECTION (COMBINATION METER ECU BRANCH WIRE)


    C139156E02
  1. Turn the ignition switch off.

  1. Disconnect the D1 combination meter ECU connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D1-20 (CANH) - D1-21 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO COMBINATION METER ECU (CAN-H, CAN-L)
OK


2.CHECK HARNESS AND CONNECTOR (IG2, ECUB, ET)
  1. Disconnect the D1 combination meter ECU connector.



    C139156E03
  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D1-24 (ET) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D1-1(IG2) - Body ground
    Ignition switch on (IG)
    11 to 14 V
    D1-2 (ECUB) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ECU