Home › BODY › EXTERIOR › FRONT DOOR BELT MOULDING (for Sedan)

FRONT DOOR BELT MOULDING (for Sedan) > INSTALLATION

for Preparation Click here


HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. INSTALL FRONT DOOR BELT MOULDING


    B134875
  1. Engage the 6 claws and install a new front door belt moulding.



    B134873E02
  1. Remove the protective tape.



2. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY


B136162E02
  1. Engage the claw and install the outer rear view mirror with the 3 nuts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. w/ Power mirror:
    Connect the connector.



3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    B136161
  1. w/ Power window:

    1. Connect the front door lock remote control cable and front door inside locking cable.



    2. B136160
    3. Engage the 9 clips and install the front door trim board.



    4. B136159
    5. Tighten the screw.



  1. w/o Power window:



      B136194
    1. Connect the front door lock remote control cable and front door inside locking cable.



    2. B136192
    3. Engage the 9 clips and install the front door trim board.



    4. B136193
    5. Tighten the screw.



4. INSTALL FRONT DOOR ARMREST BASE UPPER PANEL


B136158
  1. for Driver side with power window:

    1. Connect the connector.

    2. Engage the 7 claws and 2 clips and install the front armrest base upper panel.

    3. Tighten the screw.



    B140702
  1. for Front passenger side with power window:

    1. Connect the connector.

    2. Engage the 7 claws and 2 clips and install the front armrest base upper panel.

    3. Tighten the screw.



    B136191
  1. w/o Power window:

    1. Engage the 5 clips and 2 clips and install the front armrest base upper panel.

    2. Tighten the screw.



5. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH


B136157E02
  1. Engage the claw and clip and install the front door lower frame bracket garnish.



6. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY


B136196E01
  1. Install the window regulator handle plate.

  1. Open all the windows.



    B129030E01
  1. Install the front door window regulator handle with the clip at the angle shown in the illustration.