Home › BODY › EXTERIOR › FRONT DOOR BELT MOULDING (for Sedan)

FRONT DOOR BELT MOULDING (for Sedan) > REMOVAL

for Preparation Click here


HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


B136189
  1. Insert a clip remover between the plate and door trim.

  1. Turn the handle with the clip remover inserted, as shown in the illustration.

  1. Remove the front door window regulator handle and clip.

  1. Remove the window regulator handle plate.



2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH


B136157E02
  1. Disengage the claw and clip and remove the front door lower frame bracket garnish.



3. REMOVE FRONT DOOR ARMREST BASE UPPER PANEL


B136158
  1. for Driver side with power window:

    1. Remove the screw.

    2. Disengage the 7 claws and 2 clips and remove the front armrest base upper panel.

    3. Disconnect the connector.



    B140702
  1. for Front passenger side with power window:

    1. Remove the screw.

    2. Disengage the 7 claws and 2 clips and remove the front armrest base upper panel.

    3. Disconnect the connector.



    B136191
  1. w/o Power window:

    1. Remove the screw.

    2. Disengage the 5 claws and 2 clips and remove the front armrest base upper panel.



4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    B136159
  1. w/ Power window:

    1. Remove the screw.



    2. B136160
    3. Disengage the 9 clips.



    4. B136161
    5. Disconnect the front door lock remote control cable and front door inside locking cable and remove the front door trim board.



    B136193
  1. w/o Power window:

    1. Remove the screw.



    2. B136192
    3. Disengage the 9 clips.



    4. B136194
    5. Disconnect the front door lock remote control cable and front door inside locking cable and remove the front door trim board.



5. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY


B136162E02
  1. w/ Power mirror:
    Disconnect the connector.

  1. Remove the 3 nuts, disengage the claw and remove the outer rear view mirror.



6. REMOVE FRONT DOOR BELT MOULDING


    B134873E02
  1. Apply protective tape to the door panel in the periphery of the front door belt moulding.



    B134874E02
  1. Using a moulding remover, disengage the 6 claws and remove the front door belt moulding.