Home › BODY › EXTERIOR › FRONT BUMPER (for Hatchback)

FRONT BUMPER (for Hatchback) > REMOVAL

for Preparation Click here



1. REMOVE FRONT BUMPER COVER


    B185052E01
  1. Apply protective tape as shown in the illustration.



    B185053
  1. Remove the 8 screws.

  1. Remove the 2 screw grommets.

  1. Remove the 7 clips.



    B185054E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the front bumper cover.

  1. Disconnect the 2 connectors.

    HINT:
    If the vehicle is equipped with fog lights, disconnect the connectors.



    B114366
  1. Remove the 2 clips and the screw grommet.



2. REMOVE HEADLIGHT ASSEMBLY LH


E107913
  1. Remove the 3 screws.

  1. w/ Headlight leveling:
    Disconnect the 4 connectors, then remove the headlight.

  1. w/o Headlight leveling:
    Disconnect the 3 connectors, then remove the headlight.



3. REMOVE HEADLIGHT ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



4. REMOVE FRONT BUMPER SIDE RETAINER LH


    B114367
  1. Remove the screw.

  1. Using a clip remover, disengage the 2 claws and remove the front bumper side retainer.



5. REMOVE FRONT BUMPER SIDE RETAINER RH

HINT:
Use the same procedure as for the LH side.



6. REMOVE RADIATOR SUPPORT UPPER ABSORBER


    B208832
  1. Using a screwdriver, disengage the 6 claws and remove the radiator support upper absorber.



7. REMOVE ENGINE UNDER COVER LH


8. REMOVE ENGINE UNDER COVER RH


9. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY (for Rough Road Area Specification Vehicles)


10. REMOVE FRONT BUMPER LOWER ABSORBER (w/ Front Bumper Lower Absorber)


    B209557
  1. Using a clip remover, remove the 6 clips.

  1. Remove the 4 screws and the front bumper absorber lower.



11. REMOVE RADIATOR SIDE AIR SEAL LH (w/o Radiator Support Extension)


    B209556
  1. Disengage the 3 claws and remove the radiator side air seal.



12. REMOVE RADIATOR SIDE AIR SEAL RH (w/o Radiator Support Extension)

HINT:
Use the same procedure as for LH side.



13. REMOVE RADIATOR SIDE AIR SEAL LH (w/ Radiator Support Extension)


    B208833
  1. Disengage the 2 claws and remove the radiator side air seal.



14. REMOVE RADIATOR SIDE AIR SEAL RH (w/ Radiator Support Extension)

HINT:
Use the same procedure as for the LH side.



15. SEPARATE THERMISTOR ASSEMBLY (w/ Air Conditioning System)


    B208834
  1. Remove the 2 clamps and separate the thermistor.



16. REMOVE RADIATOR SUPPORT EXTENSION LH (w/ Radiator Support Extension)


    B114370
  1. Disengage the 2 claws and remove the radiator support extension.



17. REMOVE RADIATOR SUPPORT EXTENSION RH (w/ Radiator Support Extension)

HINT:
Use the same procedure as for the LH side.



18. DISCONNECT NO. 2 ENGINE ROOM WIRE (w/ Fog Light)


    B114372
  1. Using a clip remover, remove the 6 clamps.



19. DISCONNECT NO. 2 ENGINE ROOM WIRE (w/o Fog Light)


    B114374
  1. Using a clip remover, remove the 5 clamps.



20. REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY


    B114373
  1. Remove the 4 nuts, the 6 bolts and the front bumper reinforcement.



21. REMOVE FRONT BUMPER STONE DEFLECTOR BRACKET (w/o Radiator Support Extension)


B114582

HINT:
Use the same procedure for both sides.

  1. Remove the 2 nuts and the front bumper stone deflector bracket.



22. REMOVE FRONT BUMPER STONE DEFLECTOR BRACKET (w/ Radiator Support Extension)

HINT:
Use the same procedure for both sides.



    B126992
  1. Remove the 2 nuts and the front bumper stone deflector bracket.



23. REMOVE WINDSHIELD WASHER JAR ASSEMBLY


    B114584
  1. Remove the 2 bolts and the windshield washer jar.



24. REMOVE FRONT BUMPER ARM SUB-ASSEMBLY LH


    B114583
  1. Remove the 4 bolts and the front bumper arm.



25. REMOVE FRONT BUMPER ARM SUB-ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.