Home › BODY › EXTERIOR › REAR DOOR BELT MOULDING (for Hatchback)

REAR DOOR BELT MOULDING (for Hatchback) > INSTALLATION

for Preparation Click here


HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. INSTALL REAR DOOR BELT MOULDING


    B114406
  1. Engage the 5 claws and the clip and install a new rear door belt moulding.



    B114404E01
  1. Remove the protective tape.



2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
  1. w/ Power Window:

    1. Install the rear door trim board sub-assembly .

  1. w/o Power Window:

    1. Install the rear door trim board sub-assembly .



3. INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


B116863
  1. Install the window regulator handle plate.

  1. Open all the windows.



    B121530E01
  1. Install the rear door window regulator handle with the clip at the angle shown in the illustration.