Home › BODY › EXTERIOR › REAR DOOR BELT MOULDING (for Hatchback)

REAR DOOR BELT MOULDING (for Hatchback) > REMOVAL

for Preparation Click here


HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


B116942
  1. Insert a clip remover between the plate and door trim.

  1. Turn the handle with the clip remover inserted, as shown in the illustration.

  1. Remove the rear door window regulator handle assembly and clip.

  1. Remove the window regulator handle plate.



2. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
  1. w/ Power Window:

    1. Remove the rear door trim board sub-assembly .

  1. w/o Power Window:

    1. Remove the rear door trim board sub-assembly .



3. REMOVE REAR DOOR BELT MOULDING


    B114404E01
  1. Apply protective tape to the door panel in the area around the rear door belt moulding.



    B114405E01
  1. Using a moulding remover, disengage the 5 claws and the clip and remove the rear door belt moulding.