Home › BODY › EXTERIOR › ROOF DRIP SIDE FINISH MOULDING (for Hatchback)

ROOF DRIP SIDE FINISH MOULDING (for Hatchback) > INSTALLATION

for Preparation Click here


HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. INSTALL NO. 1 ROOF DRIP SIDE FINISH MOULDING CLIP


B114414E01

NOTICE:
Only follow this procedure when replacing the clips.

  1. Remove the tape that remains on the moulding surface of the vehicle body, then clean the surface with a non-residue solvent.

  1. Using an infrared light, heat the clip installation surface of the vehicle body and roof drip side finish moulding.
    Heating Temperature: 
    Area
    Temperature
    Vehicle Body
    40 to 60°C (104 to 140°F)
    Roof Drip Side Finish Moulding
    20 to 30°C (68 to 86°F)

    NOTICE:
    Do not excessively heat the vehicle body or roof drip side finish moulding.

  1. Install new clips in the positions shown in the illustration. Press in the clips by hand.
    Specification: 
    Area
    Measurement
    a
    35.4 mm (1.394 in.)
    b
    0.8 mm (0.032 in.)
    c
    1.6 mm (0.063 in.)
    d
    24 mm (0.945 in.)
    e
    0.5 mm (0.02 in.)
    f
    2.7 mm (0.106 in.)

    NOTICE:
    After pressing in the clips, wait 30 minutes or more before installing the roof drip side finish moulding.

    HINT:
    1. Minimum hardening time: 30 minutes
    2. Time needed for complete hardening: 24 hours



2. INSTALL ROOF DRIP SIDE FINISH MOULDING


    B114413
  1. Engage the 2 clips and install the roof drip side finish moulding.



    B114412E01
  1. Remove the protective tape.