Home › BODY › EXTERIOR › ROOF DRIP SIDE FINISH MOULDING (for Hatchback)

ROOF DRIP SIDE FINISH MOULDING (for Hatchback) > REMOVAL

for Preparation Click here


HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. REMOVE ROOF DRIP SIDE FINISH MOULDING


    B114412E01
  1. Apply protective tape to the roof panel in the area around the roof drip side finish moulding.



    B114413
  1. Disengage the 2 clips and remove the roof drip side finish moulding.

    NOTICE:
    1. Do not remove the clips.
    2. Replace the clips with supply clips if damaged.