Home › BODY › EXTERIOR › REAR BUMPER (for Hatchback)

REAR BUMPER (for Hatchback) > REMOVAL

for Preparation Click here



1. REMOVE REAR BUMPER SIDE SEAL LH


    B185033
  1. Using a clip remover, remove the 2 clips and the rear bumper side seal.



2. REMOVE REAR BUMPER SIDE SEAL RH

HINT:
Use the same procedure as for the LH side.



3. REMOVE REAR BUMPER COVER


    B185034E01
  1. Apply protective tape as shown in the illustration.



    B185035
  1. Using a clip remover, remove the 2 clips.

  1. Remove the 2 bolts.



    B208838E01
  1. From the inside of the rear fender, push the edge of the rear bumper towards the front of the vehicle and, using a screwdriver wrapped in protective tape, disengage the bottom claw. At the same time, pull the side of the bumper outward.



    B189571
  1. Slowly pull the side of the bumper outward and disengage the 2nd, 3rd, and 4th claws from the side of the bumper, starting at the bottom and moving upward.

  1. Disengage the 4 claws and remove the rear bumper cover.

  1. Disconnect the license plate light connector.



4. REMOVE REAR BUMPER SIDE RETAINER LH


    B114390
  1. Remove the screw.

  1. Using a clip remover, disengage the 2 claws and remove the rear bumper side retainer.



5. REMOVE REAR BUMPER SIDE RETAINER RH

HINT:
Use the same procedure as for the LH side.



6. REMOVE REAR BUMPER REINFORCEMENT (w/o Rear Bumper Arm)


    B114391
  1. Remove the 6 bolts and the rear bumper reinforcement.



7. REMOVE REAR BUMPER REINFORCEMENT NO.1 (w/ Rear Bumper Arm)


    B114620
  1. Remove the 4 nuts and the rear bumper reinforcement.



8. REMOVE REAR BUMPER ARM SUB-ASSEMBLY LH (w/ Rear Bumper Arm)


    B114631
  1. Remove the 3 bolts and the rear bumper arm.



9. REMOVE REAR BUMPER ARM SUB-ASSEMBLY RH (w/ Rear Bumper Arm)

HINT:
Use the same procedure as for the LH side.