NO. 1 BLACK OUT TAPE (for Hatchback) > INSTALLATION |
| 1. INSTALL NO. 1 BLACK OUT TAPE |
Application precautions.
Application temperature
Pre-application procedure:
Handling:
Application method (Method of squeegee operation and application for general portions):

![]() |
Application method (Method of squeegee operation and application method for hemming portions):
Application method (Method of squeegee operation and application method for corner sections):
Inspection:
Clean the attachment surface (Using an infrared light).
Using an infrared light, heat any black out tape and adhesive remaining on the body.
Using a shop rag or piece of cloth, rub the remaining black out tape and adhesive off the body.
Using a non-residue solvent, clean the attachment surface.
Clean the attachment surface (Using a tape removal disc).
Set the 8 discs in the holder and insert the removal disc into an air drill or electric drill.
Using a tape removal disc, rub the remaining black out tape and adhesive off the body.
Using a non-residue solvent, clean the attachment surface.
Apply new No. 1 black out tape to the positions shown in the illustration.

| Mark | Measurement (along surface) |
| a | +-1 mm (+-0.039 in.) |
| b | 0 to 1.8 mm (0 to 0.071 in.) |
| c | 2 mm (0.079 in.) |
| d | 1.2 to 3.2 mm (0.047 to 0.126 in.) |
| e | 2 to 4 mm (0.079 to 0.157 in.) |
| 2. INSTALL FRONT DOOR GLASS RUN |
![]() |
Install the front door glass run.
| 3. INSTALL FRONT DOOR BELT MOULDING |
![]() |
for 5 Door:
Engage the 5 claws and the clip and install a new front door belt moulding.
![]() |
Remove the protective tape.
![]() |
for 3 Door:
Engage the 5 claws and the clip and install a new front door belt moulding.
![]() |
Remove the protective tape.
| 4. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY |
![]() |
Engage the claw, then install the outer rear view mirror with the 3 nuts.
w/ Power mirror:
Connect the connector.
| 5. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
w/ Power Window:
Install the front door trim board sub-assembly .
w/o Power Window:
Install the front door trim board sub-assembly .
| 6. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) |
![]() |
Install the window regulator handle plate.
Open all the windows.
![]() |
Install the front door window regulator handle with clip at the angle shown in the illustration.
| 7. INSTALL FRONT DOOR ARMREST BASE UPPER PANEL |
w/ Power Window:
Install the front door armrest base upper panel .
w/o Power Window:
Install the front door armrest base upper panel .
| 8. INSTALL FRONT DOOR ARMREST COVER |
![]() |
for 5 Door:
Engage the 8 claws and 3 clips and install the door armrest cover.
![]() |
for 3 Door:
Engage the 12 claws and 4 clips and install the door armrest cover.