NO. 1 BLACK OUT TAPE (for Sedan) > INSTALLATION |
| 1. INSTALL NO. 1 BLACK OUT TAPE |
Application precautions.
Application temperature:
Pre-application procedure:
Handling:
Application method (Method of squeegee operation and application for general portions):

![]() |
Application method (Method of squeegee operation and application method for hemming portions):
Application method (Method of squeegee operation and application method for corner sections):
Inspection:
Clean the attachment surface (Using an infrared light).
Using an infrared light, heat any black out tape and adhesive remaining on the body.
Using a shop rag or piece of cloth, rub the remaining black out tape and adhesive off the body.
Using a non-residue solvent, clean the attachment surface.
Clean the attachment surface (Using a tape removal disc).
Set the 8 discs in the holder and insert the removal disc into an air drill or electric drill.
Using a tape removal disc, rub the remaining black out tape and adhesive off the body.
Using a non-residue solvent, clean the attachment surface.
Apply new No. 1 black out tape to the positions shown in the illustration.

| Mark | Measurement (along surface) |
| a | -1 to 1 mm (-0.039 to 0.039 in.) |
| b | 2 mm (0.079 in.) |
| c | 0 to 1.8 mm (0 to 0.071 in.) |
| d | 3 to 5 mm (0.118 to 0.197 in.) |
| e | 2 to 4 mm (0.079 to 0.157 in.) |
| 2. INSTALL FRONT DOOR GLASS RUN |
![]() |
Install the front door glass run, then engage the clip.
| 3. INSTALL FRONT DOOR BELT MOULDING |
![]() |
Engage the 6 claws and install a new front door belt moulding.
![]() |
Remove the protective tape.
| 4. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY |
![]() |
Engage the claw and install the outer rear view mirror with the 3 nuts.
w/ Power mirror:
Connect the connector.
| 5. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
![]() |
w/ Power window:
Connect the front door lock remote control cable and front door inside locking cable.
![]() |
Engage the 9 clips and install the front door trim board.
![]() |
Tighten the screw.
w/o Power window:
![]() |
Connect the front door lock remote control cable and front door inside locking cable.
![]() |
Engage the 9 clips and install the front door trim board.
![]() |
Tighten the screw.
| 6. INSTALL FRONT DOOR ARMREST BASE UPPER PANEL |
![]() |
for Driver side with power window:
Connect the connector.
Engage the 7 claws and 2 clips and install the front armrest base upper panel.
Tighten the screw.
![]() |
for Front passenger side with power window:
Connect the connector.
Engage the 7 claws and 2 clips and install the front armrest base upper panel.
Tighten the screw.
![]() |
w/o Power window:
Engage the 5 clips and 2 clips and install the front armrest base upper panel.
Tighten the screw.
| 7. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH |
![]() |
Engage the claw and clip and install the front door lower frame bracket garnish.
| 8. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) |
![]() |
Install the window regulator handle plate.
Open all the windows.
![]() |
Install the front door window regulator handle with the clip at the angle shown in the illustration.