Home › BODY › EXTERIOR › NO. 1 BLACK OUT TAPE (for Hatchback)

NO. 1 BLACK OUT TAPE (for Hatchback) > REMOVAL

for Preparation Click here


HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. REMOVE FRONT DOOR ARMREST COVER


B116818
  1. for 5 Door:
    Using a screwdriver with its tip wrapped in protective tape, disengage the 8 claws and 3 clips and remove the door armrest cover.



    B116851
  1. for 3 Door:
    Disengage the 12 claws and 3 clips and remove the door armrest cover.



2. REMOVE FRONT DOOR ARMREST BASE UPPER PANEL
  1. w/ Power Window:

    1. Remove the front door armrest base upper panel .

  1. w/o Power Window:

    1. Remove the front door armrest base upper panel .



3. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


B116850
  1. Insert a clip remover between the plate and door trim.

  1. Turn the handle with the clip remover inserted, as shown in the illustration.

  1. Remove the front door window regulator handle and clip.

  1. Remove the window regulator handle plate.



4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
  1. w/ Power Window:

    1. Remove the front door trim board sub-assembly .

  1. w/o Power Window:

    1. Remove the front door trim board sub-assembly .



5. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY


B118045
  1. w/ Power mirror:
    Disconnect the connector.

  1. Remove the 3 nuts, disengage the claw and remove the outer rear view mirror.



6. REMOVE FRONT DOOR BELT MOULDING


    B114397E02
  1. for 5 Door:

    1. Apply protective tape to the door panel in the area around the front door belt moulding.



    2. B114398E02
    3. Using a moulding remover, disengage the 5 claws and the clip and remove the front door belt moulding.



    B114612E01
  1. for 3 Door:

    1. Apply protective tape to the door panel in the area around the front door moulding.



    2. B114613E01
    3. Using a moulding remover, disengage the 5 claws and remove the front door belt moulding.



7. REMOVE FRONT DOOR GLASS RUN


B116826
  1. Remove the front door glass run.



8. REMOVE NO. 1 BLACK OUT TAPE


    B108308
  1. Using an infrared light, heat the No. 1 black out tape.

    NOTICE:
    Do not burn yourself with the heated front door panel or infrared light.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.

  1. Lift the end portion with your nail and peel it parallel to the attachment surface.