Home › BODY › EXTERIOR › NO. 2 BLACK OUT TAPE (for Sedan)

NO. 2 BLACK OUT TAPE (for Sedan) > INSTALLATION

for Preparation Click here


HINT:
The procedure described below is for the LH side. Use the same procedure for the RH and LH sides, unless otherwise specified.



1. INSTALL NO. 2 BLACK OUT TAPE
  1. Application precautions .

  1. Clean the attachment surface (Using an infrared light) .

  1. Clean the attachment surface (Using a tape removal disc) .



  1. Apply new No. 1 black out tape to the positions shown in the illustration.


    B134886E03

    Installation position:
    Mark
    Measurement (along surface)
    a
    -1 to 1 mm (-0.039 to 0.039 in.)
    b
    0 to 1.8 mm (0 to 0.071 in.)
    c
    2 mm (0.079 in.)
    d
    2 to 4mm (0.079 to 0.157 in.)
    e
    3 to 5 mm (0.118 to 0.197 in.)



2. INSTALL REAR DOOR GLASS RUN


B136213
  1. Install the rear door glass run.



3. INSTALL REAR DOOR BELT MOULDING


    B134882
  1. Engage the 5 claws and install a new rear door belt moulding.



    B134880E03
  1. Remove the protective tape.



4. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY


B208701
  1. Connect the rear door lock remote control cable and rear door inside locking cable.



    B208700
  1. Engage the 7 clips and install the rear door trim board.



    B208699
  1. Tighten the screw.



5. INSTALL REAR DOOR ARMREST BASE UPPER PANEL


B208698
  1. Engage the 4 claws and install the rear door armrest base upper panel.



6. INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


B136197E01
  1. Install the window regulator handle plate.

  1. Open all the windows.



    B129030E01
  1. Install the rear door window regulator handle with the clip at the angle shown in the illustration.