Home › BODY › EXTERIOR › NO. 2 BLACK OUT TAPE (for Hatchback)

NO. 2 BLACK OUT TAPE (for Hatchback) > REMOVAL

for Preparation Click here


HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


B116942
  1. Insert a clip remover between the plate and door trim.

  1. Turn the handle with the clip remover inserted, as shown in the illustration.

  1. Remove the rear door window regulator handle assembly and clip.

  1. Remove the window regulator handle plate.



2. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
  1. w/ Power Window:

    1. Remove the rear door trim board sub-assembly .

  1. w/o Power Window:

    1. Remove the rear door trim board sub-assembly .



3. REMOVE REAR DOOR BELT MOULDING


    B114404E01
  1. Apply protective tape to the door panel in the area around the rear door belt moulding.



    B114405E01
  1. Using a moulding remover, disengage the 5 claws and the clip and remove the rear door belt moulding.



4. REMOVE REAR DOOR GLASS RUN


B116877
  1. Remove the rear door glass run.



5. REMOVE NO. 2 BLACK OUT TAPE


    B108314
  1. Using an infrared light, heat the No. 2 black out tape.

    NOTICE:
    Do not burn yourself with the heated front door panel or infrared light.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.

  1. Lift the end portion with your nail and peel it parallel to the attachment surface.