Home › BODY › EXTERIOR › NO. 2 BLACK OUT TAPE (for Sedan)

NO. 2 BLACK OUT TAPE (for Sedan) > REMOVAL

for Preparation Click here


HINT:
The procedure described below is for the LH side. Use the same procedure for the RH and LH sides, unless otherwise specified.



1. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


B140700
  1. Insert a clip remover between the plate and door trim.

  1. Turn the handle with the clip remover inserted, as shown in the illustration.

  1. Remove the rear door window regulator handle assembly and clip.

  1. Remove the window regulator handle plate.



2. REMOVE REAR DOOR ARMREST BASE UPPER PANEL


B208698
  1. Disengage the 4 claws and remove the rear door armrest base upper panel.



3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


    B208699
  1. Remove the screw.



    B208700
  1. Disengage the 7 clips.



    B208701
  1. Disconnect the rear door lock remote control cable and rear door inside locking cable and remove the rear door trim board.



4. REMOVE REAR DOOR BELT MOULDING


    B134880E03
  1. Apply protective tape to the door panel in the periphery of the rear door belt moulding.



    B134881E02
  1. Using a moulding remover, disengage the 5 claws and remove the rear door belt moulding.



5. REMOVE REAR DOOR GLASS RUN


B136213
  1. Remove the rear door glass run.



6. REMOVE NO. 2 BLACK OUT TAPE


    B134885
  1. Using an infrared light, heat the No. 2 black out tape.

    NOTICE:
    Do not burn yourself with the heated front door panel or infrared light.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.

  1. Lift the end portion with your nail and peel it parallel to the attachment surface.