METER / GAUGE SYSTEM (for Hatchback) > Entire Combination Meter does not Operate |

| 1.CHECK FUSE (ECU-B, MET) |
![]() |
Remove the ECU-B fuse from the engine room relay block.
Remove the MET fuse from the main body ECU.
Measure the resistance.
Reinstall the fuses.
|
| ||||
| OK | |
| 2.INSPECT COMBINATION METER ASSEMBLY |
![]() |
Disconnect the D1 combination meter assembly connector.
Measure the resistance.
| Terminal No. | Condition | Specified Condition |
| D1-24 (ET) - Body ground | Always | Below 1 Ω |
Measure the voltage.
| Terminal No. | Condition | Specified Condition |
| D1-1 (IG2) - Body ground | Ignition switch ON | 10 to 14 V |
| D1-2 (ECU-B) - Body ground | Always | 10 to 14 V |
Reconnect the combination meter assembly connector.
|
| ||||
| OK | ||
| ||