Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM (for Sedan)

METER / GAUGE SYSTEM (for Sedan) > Entire Combination Meter does not Operate

for Preparation Click here


DESCRIPTION

This circuit provides power to the combination meter assembly.

WIRING DIAGRAM


E173951E01


INSPECTION PROCEDURE

1.CHECK FUSE (ECU-B, MET)


    E117120E01
  1. Remove the ECU-B fuse from the engine room relay block.

  1. Remove the MET fuse from the main body ECU.

  1. Measure the resistance.

    Standard resistance:
    Below 1Ω

  1. Reinstall the fuses.



NG
CHECK SHORT CIRCUIT IN COMPONENTS AND WIRES CONNECTED TO FUSE
OK


2.INSPECT COMBINATION METER ASSEMBLY
E114496E06
  1. Disconnect the D1 combination meter assembly connector.

  1. Measure the resistance.

    Standard resistance:
    Terminal No.
    Condition
    Specified Condition
    D1-24 (ET) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage.

    Standard voltage:
    Terminal No.
    Condition
    Specified Condition
    D1-1 (IG2) -
    Body ground
    Ignition switch ON
    10 to 14 V
    D1-2 (ECU-B) -
    Body ground
    Always
    10 to 14 V

  1. Reconnect the combination meter assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY