Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM (for Hatchback)

METER / GAUGE SYSTEM (for Hatchback) > Tachometer Malfunction

for Preparation Click here


DESCRIPTION

The combination meter assembly controls the tachometer in accordance with engine speed signals from the ECM through the CAN communication system.

WIRING DIAGRAM


E114498E25


INSPECTION PROCEDURE

HINT:
If DTC U0100 has been stored, troubleshoot the CAN communication system first.

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (TACHOMETER)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON and turn the tester on.

  1. Perform the Active Test according to the prompts displayed on the tester.

    Combination Meter:

    Item
    Test Details
    Diagnostic Note
    TachoMeter Operation
    0 rpm / 1,000 rpm / 2,000 rpm / 3,000 rpm / 4,000 rpm / 5,000 rpm / 6,000 rpm / 7,000 rpm
    -

    OK:
    Engine speed displayed on the tester is approximately the same as that of the tachometer reading.



NG
REPLACE COMBINATION METER ASSEMBLY
OK


2.READ VALUE USING INTELLIGENT TESTER (ENGINE RPM)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON and turn the tester on.

  1. Read the Data List according to the prompts displayed on the tester.

    Combination Meter:

    Item
    Measurement Item/Range
    (Display)
    Normal Condition
    Diagnostic Note
    Engine Rpm
    Engine speed / Min.: 0 rpm, Max.: 12,750 rpm
    Approximately same as actual engine speed (When engine is running)
    -

    OK:
    Engine speed displayed on the tester is approximately the same as the actual engine speed.



NG
GO TO SFI SYSTEM
OK

REPLACE COMBINATION METER ASSEMBLY