Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM (for Sedan)

METER / GAUGE SYSTEM (for Sedan) > Malfunction in Water Temperature Warning Light

for Preparation Click here


DESCRIPTION

The combination meter assembly controls the engine coolant temperature warning light in accordance with engine coolant temperature signals from the ECM through the CAN communication system. The engine coolant temperature indicator light turns off when the engine coolant temperature exceeds 55°C (131°F) and illuminates when the temperature decreases to below 45°C (113°F). The engine coolant temperature warning light flashes when the engine coolant temperature reaches 117°C (242.6°F) and illuminates when the temperature exceeds 120°C (248°F). When the temperature decreases to 119.5°C (247.1°F) while the warning light is illuminated, the warning light begins to flashing. In addition, when the temperature decreases to below 116.5°C(241.7°F) the warning light turns off.

WIRING DIAGRAM


E114498E13


INSPECTION PROCEDURE

HINT:
  1. If DTC U0100 has been stored, troubleshoot the CAN communication system first.
  2. If there is an open or short in the engine coolant temperature sensor circuit, an SFI system DTC is output. If output, perform troubleshooting on the SFI system related DTC first.

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (WATER TEMPERATURE METER)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON and turn the tester on.

  1. Perform the Active Test according to the prompts displayed on the tester.

    Combination Meter:

    Item
    Test Details
    Diagnostic Note
    Indicat. Light Coolant Hot
    Engine coolant temperature warning light (OFF / ON)
    -
    Indicat. Light Coolant Cool
    Engine coolant temperature indicator light (OFF / ON)
    -
    Water Temperature Meter Operation
    HIGH: Engine coolant temperature warning light flashes
    NORMAL: Both engine coolant temperature warning light and indicator light turn off
    LOW: Engine coolant temperature indicator light illuminates
    -

    OK:
    Both the engine coolant temperature warning light and indicator light are operated in accordance with the tester operations.



NG
REPLACE COMBINATION METER ASSEMBLY
OK


2.READ VALUE USING INTELLIGENT TESTER (COOLANT TEMPERATURE)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON and turn the tester on.

  1. Read the Data List according to the prompts displayed on the tester.

    Combination Meter:

    Item
    Measurement Item / Range (Display)
    Normal Condition
    Diagnostic Note
    Coolant Temperature
    Engine coolant temperature / Min.: 0°C, MAX.: 127.5°C
    After warming up: 75 to 105°C (167 to 221°F)
    -

    OK:
    Engine coolant temperature displayed on the tester is between 75°C (167°F) and 105°C (221°F) after warming up.

    HINT:
    If the value is 0°C (32°F), the sensor circuit is open.
    If the value is 127.5°C (262°F), the sensor circuit is shorted.



NG
GO TO ENGINE CONTROL SYSTEM
OK

REPLACE COMBINATION METER ASSEMBLY