Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM

AIR CONDITIONING SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST
B145842E01

HINT:
Using the intelligent tester's Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG) and turn the intelligent tester on.

  3. Read the Data List by following the prompts on the tester screen.

    Data List 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Ambi Temp Sens
    Ambient temperature sensor /
    Min.: -23.3 °C (-9.94 °F)
    Max.: 65.95 °C (150.71 °F)
    Actual ambient temperature is displayed
    -
    Coolant Temp
    Engine coolant temperature /
    Min.: 1.3 °C (34.34 °F)
    Max.: 90.55 °C (194.99 °F)
    Actual engine coolant temperature is displayed after engine warmed up
    -
    Ambi Temp
    Adjusted ambient temperature /
    Min.: -30.8 °C (-23.44 °F)
    Max.: 50.8 °C (123.44 °F)
    -
    -
    Evap Fin Temp
    Evaporator temperature sensor /
    Min.: -29.7 °C (-21.46 °F)
    Max.: 59.55 °C (139.19 °F)
    Actual evaporator temperature is displayed
    -
    Reg Press Sens
    Regulator pressure sensor /
    Min.: 0 kgf/cm2G
    Max.: 38.25 kgf/cm2G
    Actual regulator pressure is displayed
    -
    Reg Ctrl Currnt
    Regulator control current /
    Min.: 0 A
    Max.: 0.997 A
    -
    -
    Destination
    Destination / DOMEST, USA, EUROPE, AUSTRAL, MIDEAST, NO INFO
    Destinations displayed
    -
    Number of Trouble Codes
    Number of trouble codes /
    Min.: 0, Max.: 255
    Number of DTCs displayed
    -


PERFORM ACTIVE TEST

HINT:
Performing the intelligent tester's Active Test allows relays, the VSV, actuators and other items to be operated without removing any parts. Performing the Active Test early in troubleshooting is one way to save time. The Data List can be displayed in the Active Test.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG) and turn the intelligent tester on.

  3. Perform the Active Test according to the display on the tester.

    Active Test 
    Tester Display
    Test Part
    Control Range
    A/C Mag Clutch
    A/C Compressor /
    OFF, ON
    -