INPUT SHAFT > DISASSEMBLY |
| 1. REMOVE DIRECT CLUTCH DISC |
![]() |
Using a screwdriver, remove the snap ring, clutch flange, clutch discs and 2 clutch plates from the input shaft.
| 2. REMOVE DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() |
Using SST, a press and snap ring pliers, remove the snap ring and direct clutch return spring.
| 3. REMOVE DIRECT CLUTCH PISTON SUB-ASSEMBLY |
![]() |
Remove the direct clutch piston by blowing compressed air into the hole as shown in the illustration on the left.
| 4. REMOVE DIRECT CLUTCH PISTON O-RING |
![]() |
Remove the direct clutch piston O-ring from the direct clutch piston.
![]() |
Remove the direct clutch piston O-ring from the input shaft.
| 5. REMOVE INPUT SHAFT OIL SEAL RING |
![]() |
Remove the 2 input shaft oil seal rings from the input shaft.