Home › TRANSMISSION ยท U441E AUTOMATIC TRANSAXLE › INPUT SHAFT

INPUT SHAFT > REASSEMBLY

for Preparation Click here



1. INSTALL INPUT SHAFT OIL SEAL RING


C059970
  1. Coat 2 new input shaft oil seal rings with Toyota Genuine ATF Type T-IV, and install them onto the input shaft.



2. INSTALL DIRECT CLUTCH PISTON O-RING


C059969
  1. Coat a new direct clutch piston O-ring (outer) with Toyota Genuine ATF Type T-IV, and install it onto the direct clutch.



    C059940
  1. Coat a new direct clutch piston O-ring (inner) with Toyota Genuine ATF Type T-IV, and install it onto the input shaft.



3. INSTALL DIRECT CLUTCH PISTON SUB-ASSEMBLY


C059974
  1. Coat the direct clutch piston with Toyota Genuine ATF Type T-IV, and install it onto the input shaft.



4. INSTALL DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY


D025200E01
  1. Using SST, a press and snap ring pliers, install the direct clutch spring onto the input shaft with the snap ring.

    SST
    09387-00020  



5. INSTALL DIRECT CLUTCH DISC


D025201E01
  1. Coat the 2 clutch plates, 2 clutch discs and clutch flange with Toyota Genuine ATF Type T-IV and install them onto the input shaft with the snap ring.



6. INSPECT PISTON STROKE OF DIRECT CLUTCH


C059977
  1. Install the input shaft assembly onto the oil pump.

  1. Using a dial indicator and measuring terminal, measure the forward clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).

    Standard piston stroke:
    0.40 to 0.80 mm (0.0157 to 0.0315 in.)

    Flange thickness:
    Mark
    Thickness
    1
    3.0 mm (0.118 in.)
    2
    3.2 mm (0.126 in.)
    3
    3.4 mm (0.134 in.)