Home › TRANSMISSION ยท U441E AUTOMATIC TRANSAXLE › INTERMEDIATE SHAFT

INTERMEDIATE SHAFT > INSPECTION

for Preparation Click here



1. INSPECT REVERSE CLUTCH DISC


C080720
  1. Check whether the sliding surface of the disc, plate and flange are worn or burnt.
    If necessary, replace them.

    NOTICE:
    1. If the lining of the disc is peeling off or discolored, or even if a part of the printed number is defaced, replace all the discs.
    2. Before assembling new discs, soak them in Toyota Genuine ATF Type T-IV for at least 15 minutes.



2. INSPECT FRONT CLUTCH CLUTCH DISC


C059961
  1. Check whether the sliding surfaces of the disc, plate and flange are worn or burnt.
    If necessary, replace them.

    NOTICE:
    1. If the lining of the disc is peeling off or discolored, or even if a part of the printed number is defaced, replace all the discs.
    2. Before assembling new discs, soak them in Toyota Genuine ATF Type T-IV for at least 15 minutes.



3. INSPECT FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY


C060024
  1. Using vernier calipers, measure the free length of the spring together with the spring seat.

    Standard free length:
    24.04 mm (0.9465 in.)