Home › TRANSMISSION ยท U441E AUTOMATIC TRANSAXLE › INTERMEDIATE SHAFT

INTERMEDIATE SHAFT > REASSEMBLY

for Preparation Click here



1. INSTALL INTERMEDIATE SHAFT OIL SEAL RING


C059959
  1. Coat a new intermediate shaft oil seal ring with Toyota Genuine ATF Type T-IV, and install it onto the intermediate shaft.



2. INSTALL FRONT CLUTCH DRUM O-RING


C059958
  1. Coat a new front clutch drum O-ring with Toyota Genuine ATF Type T-IV, and install it onto the clutch drum.



3. INSTALL FORWARD CLUTCH PISTON O-RING


C059957
  1. Coat a new forward clutch piston O-ring with Toyota Genuine ATF Type T-IV, and install it onto the intermediate shaft.



4. INSTALL CLUTCH DRUM SUB-ASSEMBLY


C059963
  1. Coat the clutch drum with Toyota Genuine ATF Type T-IV, and install it onto the intermediate shaft.



5. INSTALL FORWARD CLUTCH PISTON


C059964
  1. Coat the forward clutch piston with Toyota Genuine ATF Type T-IV, and install it onto the intermediate shaft.



6. INSTALL FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY


C059954
  1. Coat the forward clutch return spring with Toyota Genuine ATF Type T-IV, and install it onto the intermediate shaft.



7. INSTALL CLUTCH BALANCER NO. 1
  1. Coat clutch balancer No. 1 with Toyota Genuine ATF Type T-IV, and install it onto the intermediate shaft.



    D025202E01
  1. Using SST, a press and snap ring pliers, install the snap ring.

    SST
    09387-00020  



8. INSTALL FRONT CLUTCH CLUTCH DISC


D025203E01
  1. Coat the 4 plates, 4 discs and flange with Toyota Genuine ATF Type T-IV, and install them onto the intermediate shaft with the snap ring.



9. INSTALL REVERSE CLUTCH DISC


D025204E01
  1. Coat the 2 plates, 2 discs and clutch flange with Toyota Genuine ATF Type T-IV, and install them with the snap ring onto the intermediate shaft.



10. INSPECT PACK CLEARANCE OF REVERSE CLUTCH


C059938
  1. Install the intermediate shaft onto the transaxle rear cover.

  1. Using a dial indicator, measure the clearance while applying compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).

    Standard clearance:
    0.40 to 1.00 mm (0.0157 to 0.0394 in.)

    Flange thickness:
    Mark
    Thickness
    1
    3.0 mm (0.118 in.)
    2
    3.2 mm (0.126 in.)
    3
    3.4 mm (0.135 in.)
    4
    3.6 mm (0.142 in.)



11. INSPECT PACK CLEARANCE OF FRONT CLUTCH


C059939E01
  1. Install the intermediate shaft onto the transaxle rear cover.

  1. Using a dial indicator and SST, measure the clearance while applying compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).

    SST
    09350-36010   (09350-06120)

    Standard clearance:
    1.3 to 1.5 mm (0.051 to 0.059 in.)

    Flange thickness:
    Mark
    Thickness
    1
    3.0 mm (0.118 in.)
    2
    3.2 mm (0.126 in.)
    3
    3.4 mm (0.135 in.)
    4
    3.6 mm (0.142 in.)