DIFFERENTIAL CASE > DISASSEMBLY |
| 1. REMOVE FRONT DRIVE PINION REAR TAPERED ROLLER BEARING |
![]() |
Using SST and a press, remove the front drive pinion rear tapered roller bearing (inner race) and counter driven gear from the differential drive pinion.
![]() |
Using SST, remove the front drive pinion rear tapered roller bearing (outer race) and drive pinion washer from the transaxle case.
| 2. REMOVE FRONT DRIVE PINION FRONT TAPERED ROLLER BEARING |
![]() |
Using SST and a press, remove the front drive pinion front tapered roller bearing (inner race) from the differential drive pinion.
![]() |
Using SST, remove the front drive pinion front tapered roller bearing (outer race) from the transaxle housing.
| 3. REMOVE DIFFERENTIAL DRIVE PINION PLUG |
![]() |
Using an extension bar and a hammer, remove the differential drive pinion plug.
| 4. REMOVE FRONT DIFFERENTIAL RING GEAR |
![]() |
Place matchmarks on the front differential ring gear and the differential case.
Remove the 8 bolts.
Using a plastic hammer, remove the front differential ring gear.
| 5. REMOVE FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING |
![]() |
Using SST, remove the front differential case front tapered roller bearing (inner race) from the differential case.
![]() |
Using SST, remove the front differential case front tapered roller bearing (outer race) and differential case washer.
| 6. REMOVE SPEEDOMETER DRIVE GEAR |
![]() |
Remove the speedometer drive gear from the differential case.
| 7. REMOVE FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING |
![]() |
Using SST, remove the front differential case rear tapered roller bearing (inner race) from the differential case.
![]() |
Using SST, remove the front differential case rear tapered roller bearing (outer race) and differential case washer.
| 8. REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN |
![]() |
Using a punch and hammer, loosen the staked part of the differential case.
![]() |
Using a 3 mm pin punch and hammer, remove the pinion shaft straight pin.
| 9. REMOVE FRONT DIFFERENTIAL PINION SHAFT NO. 1 |
![]() |
Remove front differential pinion shaft No. 1 from the differential case.
| 10. REMOVE FRONT DIFFERENTIAL SIDE GEAR |
![]() |
Remove the 2 front differential pinions, 2 pinion thrust washers, 2 front differential side gears and 2 side gear thrust washers from the differential case.