Home › RESTRAINTS › SEAT BELT › REAR SEAT OUTER BELT ASSEMBLY (for Hatchback 5 Door Split Seat Type)

REAR SEAT OUTER BELT ASSEMBLY (for Hatchback 5 Door Split Seat Type) > REMOVAL

for Preparation Click here


NOTICE:
Always use "TORX" socket wrench E10 when removing the rear seat.

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Luggage Compartment Room Light)


2. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)


    B114569E01
  1. Remove the 2 package tray trim suspenders.

  1. Remove the 5 pieces of hook tape.

  1. Disengage the 2 claws and remove the package tray trim.



3. REMOVE DECK BOARD SUB-ASSEMBLY (w/ Deck Board)


    B106371
  1. Release the 2 knobs and remove the deck board.



4. REMOVE SPARE WHEEL COVER ASSEMBLY (w/ Deck Board)


    B119913
  1. Remove the spare wheel cover.



5. REMOVE DECK FLOOR BOX (w/ Deck Board)
  1. for RH Side:

    1. Remove the deck floor box .

  1. for LH Side:

    1. Remove the deck floor box.

      HINT:
      Use the same procedure as for the RH side.



6. REMOVE REAR FLOOR CARPET ASSEMBLY (w/o Deck Board)


    B119912
  1. Remove the rear floor carpet.



7. REMOVE NO. 1 REAR SEAT LEG COVER
  1. for RH Side:

    1. Remove the No. 1 rear seat leg cover .

  1. for LH Side:

    1. Remove the No. 1 rear seat leg cover .



8. REMOVE NO. 2 REAR SEAT LEG COVER (for LH Side)


    B126921E01
  1. Disengage the 3 claws in the sequence shown in the illustration and remove the No. 1 rear seat leg cover.



9. REMOVE REAR SEAT ASSEMBLY
  1. for RH Side:

    1. Remove the rear seat assembly .

  1. for LH Side:

    1. Remove the rear seat assembly .



10. REMOVE REAR DOOR SCUFF PLATE


    B114287
  1. Disengage the 6 claws and remove the rear door scuff plate.



11. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP


    B114431
  1. Remove the rear door opening trim weatherstrip to the extent that the deck trim side panel and roof side inner garnish can be removed.



12. REMOVE REAR DECK TRIM COVER


    B117692
  1. for Temper Spare Tire:

    1. Using a clip remover, remove the 2 clips.

    2. Disengage the 8 claws and remove the rear deck trim cover.



    B114283
  1. for Grand Tire:

    1. Using a clip remover, remove the 2 clips.

    2. Disengage the 8 claws and remove the rear deck trim cover.



13. REMOVE DECK TRIM SIDE PANEL ASSEMBLY


    B114289
  1. Remove the belt of the rear seat outer belt from the rear seat shoulder belt hanger.



    B114454
  1. Remove the bolt.

  1. Disengage the clip and remove the anchor plate of the rear seat outer belt.



    B114573
  1. for RH Side (w/ Package Tray Trim):

    1. Remove the 3 screws.

    2. Disengage the 3 clips and the 6 claws and remove the deck trim side panel.



    B114290
  1. for RH Side (w/o Package Tray Trim):

    1. Remove the 2 screws.

    2. Disengage the 4 clips and the 6 claws and remove the deck trim side panel.



    B114574
  1. for LH Side (w/ Package Tray Trim):

    1. Remove the 3 screws.

    2. w/ Luggage Compartment Room Light:

      1. Disengage the 3 clips and the 6 claws.
      2. Disconnect the luggage compartment room light connector and remove the deck trim side panel.

    3. w/o Luggage Compartment Room Light:

      1. Disengage the 3 clips and the 6 claws and remove the deck trim side panel.



    B114291
  1. for LH Side (w/o Package Tray Trim):

    1. Remove the 2 screws.

    2. w/ Luggage Compartment Room Light:

      1. Disengage the 4 clips and the 6 claws.
      2. Disconnect the luggage compartment room light connector and remove the deck trim side panel.

    3. w/o Luggage Compartment Room Light:

      1. Disengage the 4 clips and the 6 claws and remove the deck trim side panel.



14. REMOVE REAR SEAT SHOULDER BELT HANGER


    B114433E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the rear seat shoulder belt hanger.



15. REMOVE REAR CENTER SEAT OUTER BELT ASSEMBLY (for 3 Point Type Rear Center Seat Belt)


    B114462E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the center belt guide.



16. REMOVE ROOF SIDE INNER GARNISH


    B114576E01
  1. for RH Side (w/ Curtain Shield Airbag):

    NOTICE:
    Replace the special clip with a new one because it is damaged when the roof side inner garnish is removed.


    1. for 3 Point Type Rear Center Seat Belt:

      1. Disengage the 5 clips.
      2. Pass the rear seat outer belt and the rear center seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.

    2. for 2 Point Type Rear Center Seat Belt:

      1. Disengage the 5 clips.
      2. Pass the rear seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.



    B114575
  1. for RH Side (w/o Curtain Shield Airbag):

    1. for Rear Center Seat Belt 3 Point Type:

      1. Disengage the 5 clips.
      2. Pass the rear seat outer belt and rear center seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.

    2. for Rear Center Seat Belt 2 Point Type:

      1. Disengage the 5 clips.
      2. Pass the rear seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.



    B114578E01
  1. for LH Side (w/ Curtain Shield Airbag):

    NOTICE:
    Replace the special clip with a new one because it is damaged when the roof side inner garnish is removed.


    1. Disengage the 5 clips.

    2. Pass the rear seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.



    B114577
  1. for LH Side (w/o Curtain Shield Airbag):

    1. Disengage the 5 clips.

    2. Pass the rear seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.



17. REMOVE REAR SEAT OUTER BELT ASSEMBLY


    B114434
  1. Remove the bolt and the through anchor.



    B114435
  1. Remove the bolt, the 2 hooks and the retractor.



18. REMOVE SEAT BELT HOLE SEAL


    B114436
  1. Disengage the 2 claws and remove the seat belt hole seal.