Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY (for Hatchback)

FRONT SEAT INNER BELT ASSEMBLY (for Hatchback) > INSPECTION

for Preparation Click here


HINT:
The procedure described below is for the driver side of LHD. Use the same procedure for both the front passenger and driver sides of LHD, unless otherwise specified.



1. INSPECT FRONT SEAT INNER BELT ASSEMBLY


    B117729E01
  1. for Driver Side:

    1. Check the resistance.

      1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Tongue plate fastened
      10 kΩ or higher
      Tongue plate released
      Below 1 Ω

      If the result is not as specified, replace the front seat inner belt.



    B117730E01
  1. for Front Passenger Side:

    1. Check the resistance.

      1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      A1 - B1
      Tongue plate fastened
      10 kΩ or higher
      Tongue plate released
      Below 1 Ω
      A2 - B1
      Always
      Below 1 Ω

      If the result is not as specified, replace the front seat inner belt.