Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY (for Hatchback)

FRONT SEAT INNER BELT ASSEMBLY (for Hatchback) > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ Front Seat Side Airbag) (Click here).

NOTICE:
Always use "TORX" socket wrench E10 when removing the front seat.

HINT:
The procedure described below is for the driver side of LHD. Use the same procedure for both the front passenger and driver sides of LHD, unless otherwise specified.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working (w/ Front Seat Side Airbag).



2. REMOVE FRONT SEAT UNDER TRAY (w/ Under Tray)


    B119870
  1. Remove the front seat under tray.



3. REMOVE FRONT SEAT HEADREST ASSEMBLY


    B138677E01
  1. Push in the lock button of the front seat headrest support and remove the front seat headrest.



4. REMOVE FRONT SEAT ASSEMBLY


    B119871E01
  1. Disconnect the buckle switch connector.

  1. w/ Front Seat Side Airbag:

    1. Disconnect the airbag connector.

      1. Slide the slider and disconnect the airbag connector.



    B119872
  1. Using "TORX" socket wrench E10, remove the 4 bolts and front seat.



5. REMOVE FRONT SEAT INNER BELT ASSEMBLY


    B209777
  1. for Drive Side:

    1. Disengage the 2 hooks and remove the front seat cushion cover.

    2. Remove the buckle switch connector.

    3. Remove the 4 clamps.



    4. B114766
    5. Remove the wire harness from the claw of the front seat cushion shield.

    6. Remove the bolt and the front seat inner belt.



    B209774
  1. for Front Passenger Side:

    1. Disengage the 2 hooks and remove the front seat cushion cover.

    2. Disconnect the occupant detection sensor connector.

    3. Remove the buckle switch connector.

    4. Remove the 5 clamps.



    5. B114762
    6. Remove the wire harness from the claw of the front seat cushion shield.

    7. Remove the bolt and the front seat inner belt.