Home › RESTRAINTS › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY (for Hatchback 5 Door)

FRONT SEAT OUTER BELT ASSEMBLY (for Hatchback 5 Door) > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.



2. REMOVE FRONT DOOR SCUFF PLATE


    B114284
  1. Disengage the 8 claws and remove the front door scuff plate.



3. REMOVE REAR DOOR SCUFF PLATE


    B114287
  1. Disengage the 6 claws and remove the rear door scuff plate.



4. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP


    B114419
  1. Remove the front door opening trim weatherstrip to the extent that the center pillar upper and lower garnish can be removed.



5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP


    B114420
  1. Remove the rear door opening trim weatherstrip to the extent that the center pillar upper and lower garnish can be removed.



6. REMOVE CENTER PILLAR LOWER GARNISH


    B114297
  1. Disengage the 2 clips and the 2 claws and remove the center pillar lower garnish.



7. REMOVE SEAT BELT ANCHOR COVER CAP


    B114421E01
  1. Pull portion A, shown in the illustration, toward you, remove the 2 claws on the lower side followed by the claw on the upper side. Then remove the seat belt anchor cover cap.



8. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    B114294
  1. Remove the anchor plate cover.



    B114295
  1. Remove the bolt and the anchor plate.



    B114296
  1. Remove the bolt and the through anchor.



    B114422E01
  1. Disconnect the pretensioner connector.

    1. Using a screwdriver, release the locking button.

    2. Using a screwdriver, disconnect the pretensioner connector.



    B114423
  1. Remove the 2 bolts, the 2 hooks and the retractor.



9. REMOVE CENTER PILLAR UPPER GARNISH


    B114298
  1. Disengage the 3 clips and the 2 hooks and remove the center pillar upper garnish.



10. REMOVE SHOULDER BELT ANCHOR COVER


    B114424
  1. Disengage the 2 claws and remove the shoulder belt anchor cover.



11. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    B114425
  1. Remove the 2 bolts, the hook and the front shoulder belt anchor adjuster.