Home › RESTRAINTS › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY (for Hatchback 3 Door Rear Split Seat Type)

FRONT SEAT OUTER BELT ASSEMBLY (for Hatchback 3 Door Rear Split Seat Type) > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

NOTICE:
Always use "TORX" socket wrench E10 when removing the rear seat.

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.



2. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)


    B114569E01
  1. Remove the 2 package tray trim suspenders.

  1. Remove the 5 pieces of hook tape.

  1. Disengage the 2 claws and remove the package tray trim.



3. REMOVE DECK BOARD SUB-ASSEMBLY (w/ Deck Board)


    B106371
  1. Release the 2 knobs and remove the deck board.



4. REMOVE SPARE WHEEL COVER ASSEMBLY (w/ Deck Board)


    B119913
  1. Remove the spare wheel cover.



5. REMOVE DECK FLOOR BOX (w/ Deck Board)
  1. for RH Side:

    1. Remove the deck floor box .

  1. for LH Side:

    1. Remove the deck floor box.

      HINT:
      Use the same procedure as for the RH side.



6. REMOVE REAR FLOOR CARPET ASSEMBLY (w/o Deck Board)


    B119912
  1. Remove the rear floor carpet.



7. REMOVE NO. 1 REAR SEAT LEG COVER
  1. for RH Side:

    1. Remove the No. 1 rear seat leg cover .

  1. for LH Side:

    1. Remove the No. 1 rear seat leg cover .



8. REMOVE NO. 2 REAR SEAT LEG COVER (for LH Side)


    B126921E01
  1. Disengage the 3 claws in the sequence shown in the illustration and remove the No. 1 rear seat leg cover.



9. REMOVE REAR SEAT ASSEMBLY
  1. for RH Side:

    1. Remove the rear seat assembly .

  1. for LH Side:

    1. Remove the rear seat assembly .



10. REMOVE FRONT DOOR SCUFF PLATE


    B114494
  1. Disengage the 8 claws and remove the front door scuff plate.



11. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP


    B114477
  1. Remove the front door opening trim weatherstrip to the extent that the front quarter trim panel can be removed.



12. REMOVE FRONT SEAT OUTER BELT BAR SUB-ASSEMBLY (w/ Seat Belt Bar)


    B114759
  1. Remove the 2 bolts and the front seat outer belt bar.



13. REMOVE REAR SEAT OUTER BELT ASSEMBLY


    B114498
  1. Remove the belt.



14. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY


    B114499
  1. Disengage the 8 clips, the retainer and the 10 claws and remove the front quarter trim panel.



15. REMOVE SEAT BELT ANCHOR COVER CAP


    B114478
  1. Disengage the 3 claws and remove the seat belt anchor cover cap.



16. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    B114496
  1. w/o Seat Belt Bar:

    1. Remove the anchor plate cover.



    2. B114497
    3. Remove the bolt and the anchor plate.



    B114479
  1. Remove the bolt and the through anchor.



    B114422E01
  1. Disconnect the pretensioner connector.

    1. Using a screwdriver, release the locking button.

    2. Using a screwdriver, disconnect the pretensioner connector.



    B114423
  1. Remove the 2 bolts, the 2 hooks and the retractor.