Home › RESTRAINTS › SEAT BELT › REAR SEAT OUTER BELT ASSEMBLY (for Hatchback 3 Door Split Seat Type)

REAR SEAT OUTER BELT ASSEMBLY (for Hatchback 3 Door Split Seat Type) > REMOVAL

for Preparation Click here


NOTICE:
Always use "TORX" socket wrench E10 when removing the rear seat.

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. REMOVE CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Luggage Compartment Room Light)


2. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)


    B114569E01
  1. Remove the 2 package tray trim suspenders.

  1. Remove the 5 pieces of hook tape.

  1. Disengage the 2 claws and remove the package tray trim.



3. REMOVE DECK BOARD SUB-ASSEMBLY (w/ Deck Board)


    B106371
  1. Release the 2 knobs and remove the deck board.



4. REMOVE SPARE WHEEL COVER ASSEMBLY (w/ Deck Board)


    B119913
  1. Remove the spare wheel cover.



5. REMOVE DECK FLOOR BOX (w/ Deck Board)
  1. for RH Side:

    1. Remove the deck floor box .

  1. for LH Side:

    1. Remove the deck floor box.

      HINT:
      Use the same procedure as for the RH side.



6. REMOVE REAR FLOOR CARPET ASSEMBLY (w/o Deck Board)


    B119912
  1. Remove the rear floor carpet.



7. REMOVE NO. 1 REAR SEAT LEG COVER
  1. for RH Side:

    1. Remove the No. 1 rear seat leg cover .

  1. for LH Side:

    1. Remove the No. 1 rear seat leg cover .



8. REMOVE NO. 2 REAR SEAT LEG COVER (for LH Side)


    B126921E01
  1. Disengage the 3 claws in the sequence shown in the illustration and remove the No. 1 rear seat leg cover.



9. REMOVE REAR SEAT ASSEMBLY
  1. for RH Side:

    1. Remove the rear seat assembly .

  1. for LH Side:

    1. Remove the rear seat assembly .



10. REMOVE FRONT DOOR SCUFF PLATE


    B114494
  1. Disengage the 8 claws and remove the front door scuff plate.



11. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP


    B114477
  1. Remove the front door opening trim weatherstrip to the extent that the front quarter trim panel can be removed.



12. REMOVE REAR SEAT SHOULDER BELT HANGER


    B114498
  1. Remove the belt of the rear seat outer belt.



    B114484E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the rear seat shoulder belt hanger.



13. REMOVE FRONT SEAT OUTER BELT BAR SUB-ASSEMBLY (w/ Seat Belt Bar)


    B114759
  1. Remove the 2 bolts and the front seat outer belt bar.



14. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY


    B114499
  1. Disengage the 8 clips, retainer and 10 claws, and remove the front quarter trim panel.



15. REMOVE REAR DECK TRIM COVER


    B117692
  1. for Temper Spare Tire:

    1. Using a clip remover, remove the 2 clips.

    2. Disengage the 8 claws and remove the rear deck trim cover.



    B114283
  1. for Grand Tire:

    1. Using a clip remover, remove the 2 clips.

    2. Disengage the 8 claws and remove the rear deck trim cover.



16. REMOVE DECK TRIM SIDE PANEL ASSEMBLY


    B114500
  1. Remove the bolt.

  1. Disengage the clip and remove the anchor plate of the rear seat outer belt.



    B114501
  1. for RH Side:

    1. Remove the 3 screws.

    2. Disengage the 3 clips and the 3 claws and remove the deck trim side panel.



    B114502
  1. for LH Side:

    1. w/ Luggage Compartment Room Light:

      1. Remove the 3 screws.
      2. Disengage the 3 clips and the 3 claws.
      3. Disconnect the luggage compartment room light connector and remove the deck trim side panel.

    2. w/o Luggage Compartment Room Light:

      1. Remove the 3 screws.
      2. Disengage the 3 clips and the 3 claws and remove the deck trim side panel.



17. REMOVE REAR CENTER SEAT OUTER BELT ASSEMBLY (for 3 Point Type Rear Center Seat Belt)


    B114462E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the center belt guide.



18. REMOVE ROOF SIDE INNER GARNISH


    B114504E01
  1. for RH Side (w/ Curtain Shield Airbag):

    NOTICE:
    Replace the special clip with a new one because it is damaged when the roof side inner garnish is removed.


    1. for 3 Point Type Rear Center Seat Belt:

      1. Disengage the 4 clips and claw.
      2. Pass the rear seat outer belt and the rear center seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.

    2. for 2 Point Type Rear Center Seat Belt:

      1. Disengage the 4 clips and claw.
      2. Pass the rear seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.



    B114505
  1. for RH Side (w/o Curtain Shield Airbag):

    1. for 3 Point Type Rear Center Seat Belt:

      1. Disengage the 4 clips and claw.
      2. Pass the rear seat outer belt and the rear center seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.

    2. for 2 Point Type Rear Center Seat Belt:

      1. Disengage the 4 clips and claw.
      2. Pass the rear seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.



    B114506E01
  1. for LH Side (w/ Curtain Shield Airbag):

    NOTICE:
    Replace the special clip with a new one because it is damaged when the roof side inner garnish is removed.


    1. Disengage the 4 clips and claw.

    2. Pass the rear seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.



    B114507
  1. for LH Side (w/o Curtain Shield Airbag):

    1. Disengage the 4 clips and claw.

    2. Pass the rear seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.



19. REMOVE REAR SEAT OUTER BELT ASSEMBLY


    B114482
  1. Remove the bolt and the through anchor.



    B114483
  1. Remove the bolt, the 2 hooks and the retractor.



20. REMOVE SEAT BELT HOLE SEAL


    B114436
  1. Disengage the 2 claws and remove the seat belt hole seal.