Home › RESTRAINTS › SEAT BELT › OCCUPANT DETECTION SENSOR (for Hatchback)

OCCUPANT DETECTION SENSOR (for Hatchback) > INSPECTION

for Preparation Click here


HINT:
The procedure described below is for the LHD. Use the same procedure for both the RHD and LHD, unless otherwise specified.



1. INSPECT FRONT SEAT CUSHION COVER PAD (Built in Occupant Detection Sensor)


    B119952E02
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 3
      More than 29 N (3 kgf, 7 lbf) applied to occupant detection sensor
      Below 100 Ω
      Seat not occupied
      1 MΩ or higher

      If the result is not as specified, replace the front seat cushion cover pad.