Home › RESTRAINTS › SEAT BELT › OCCUPANT DETECTION SENSOR (for Hatchback)

OCCUPANT DETECTION SENSOR (for Hatchback) > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ Front Seat Side Airbag) (Click here).

NOTICE:
Always use "TORX" socket wrench E10 when removing the front seat.

HINT:
The procedure described below is for the LHD. Use the same procedure for both RHD and LHD, unless otherwise specified.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working (w/ Front Seat Side Airbag).



2. REMOVE FRONT SEAT HEADREST ASSEMBLY


    B138677E01
  1. Push in the lock button of the front seat headrest support and remove the front seat headrest.



3. REMOVE FRONT SEAT UNDER TRAY (w/ Under Tray)


    B119870
  1. Remove the front seat under tray.



4. REMOVE FRONT SEAT ASSEMBLY

HINT:
Use the same procedure as for the driver side .



5. REMOVE RECLINING ADJUSTER RELEASE HANDLE


    B121709E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the reclining adjuster release handle.



6. REMOVE FRONT SEAT CUSHION SHIELD RH


    B121710
  1. Remove the screw.

  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and the clip and remove the front seat cushion shield.



7. REMOVE FRONT SEAT INNER BELT ASSEMBLY


    B209774
  1. Disengage the 2 hooks and remove the front seat cushion cover.

  1. Disconnect the occupant detection sensor connector.

  1. Remove the buckle switch connector.

  1. Remove the 5 wiring harness clamps.



    B114762
  1. Remove the wiring harness from the claw of the front seat cushion shield.

  1. Remove the bolt and the front seat inner belt.



8. REMOVE FRONT SEAT CUSHION SHIELD LH


    B121711
  1. Remove the screw.

  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and the clip and remove the front seat cushion shield.



9. REMOVE FRONT SEAT CUSHION COVER PAD (Built in Occupant Detection Sensor)


    B119875
  1. Remove the front seatback cover band.



    B114700E02
  1. for Clip Type:

    1. Using a clip remover, remove the 2 clips.

  1. for J Hook Type:

    1. Disengage the 2 hooks.

  1. w/ Front Seat Side Airbag:

    1. Remove the hook tape and remove the front seat cushion cover pad fixing cover.



    B209763
  1. Remove the occupant detection sensor connector.

  1. Disengage the 2 claws and the 9 hooks.

  1. Disconnect the seat heater connector and remove the front seat cushion cover pad.