DOOR CONTROL TRANSMITTER MODULE > REGISTRATION |
| 1. REGISTER RECOGNITION CODES |
Check that the following conditions are met.
Insert the key into the ignition key cylinder, and remove it twice within 5 seconds.
Perform the following operations within 40 seconds.
Close and open the driver side door twice.
Insert the key into the ignition key cylinder, then remove it.
Perform the following operations within 40 seconds.
Close and open the driver side door twice.
Insert the key into the ignition key cylinder and close all doors.
Perform the following operations within 40 seconds.
Turn the ignition switch from LOCK to ON and back to LOCK 1 to 5 times at approximately 1 second intervals to select a mode (see the table below).

Remove the key from the ignition key cylinder.
The main body ECU automatically performs power door LOCK-UNLOCK operations to indicate which mode has been selected.

Register a new recognition code (Add Mode or Rewrite Mode) in accordance with the following procedure.
Within 45 seconds of Add Mode or Rewrite Mode being selected, press the LOCK and UNLOCK switches on the transmitter switch of the key simultaneously for 1.0 to 1.5 seconds. Within 3 seconds of moving your finger away from the switches, press either switch of the key for more than 1.0 second.
Within 5 seconds of the transmitter switch being released, the LOCK-UNLOCK operation will be automatically performed once if the registration of the recognition code is correctly completed. If the LOCK-UNLOCK operation is performed twice, the registration of the recognition code has failed, so perform the registration procedure from the beginning once again.

If multiple transmitters need to be registered, repeat the registration of a new recognition code procedure within 45 seconds of the previous registration.
If any of the following conditions is met, the Registration Mode will end.
The key is inserted into the ignition key cylinder.
Any doors are opened.
45 seconds or more elapse after code registration.
Registration of the recognition codes (Add Mode and Rewrite Mode) is completed.