Home › BODY › WINDSHIELD / WINDOWGLASS › REAR POWER WINDOW SWITCH (for Hatchback)

REAR POWER WINDOW SWITCH (for Hatchback) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


B116864E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the rear door armrest plug.



    B116866
  1. Remove the 2 screws.



    B116867
  1. Disengage the 7 clips.

  1. Disconnect the connector.



    B116868
  1. Disconnect the rear door lock remote control cable and rear door inside locking cable and remove the rear door trim board.



3. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY REAR


B116869
  1. Disengage the set plate and remove the power window regulator switch.