FRONT DRIVE SHAFT (for Hatchback) > REMOVAL |
| 1. DRAIN AUTOMATIC TRANSAXLE FLUID (for U441E Automatic Transaxle) |
Remove the drain plug and gasket, and drain ATF.
Install a new gasket and the drain plug.
| 2. DRAIN AUTOMATIC TRANSAXLE FLUID (for U340E Automatic Transaxle) |
Remove the drain plug and gasket, and drain ATF.
Install a new gasket and the drain plug.
| 3. DRAIN TRANSAXLE OIL (for C54 Manual Transaxle) |
Remove the filler plug and the gasket.
Remove the drain plug and gasket, and then drain the manual transaxle oil.
Install a new gasket and the drain plug.
| 4. REMOVE FRONT WHEEL |
| 5. REMOVE FRONT AXLE HUB NUT |
![]() |
Using SST and a hammer, release the staked part of the axle hub nut.
Using a 30 mm socket wrench, remove the axle hub nut.
| 6. SEPARATE FRONT SPEED SENSOR (w/ ABS) |
![]() |
Remove the bolt and separate the speed sensor and flexible hose.
![]() |
Remove the bolt and separate the speed sensor from the steering knuckle.
| 7. SEPARATE FRONT FLEXIBLE HOSE (w/o ABS) |
![]() |
Remove the bolt and separate the flexible hose.
| 8. SEPARATE TIE ROD END SUB-ASSEMBLY |
Remove the cotter pin and castle nut.
![]() |
Install SST (spacer B) to the threaded section of the tie rod end.
Using SST, separate the tie rod end from the front axle assembly.

| 9. SEPARATE FRONT STABILIZER LINK ASSEMBLY |
![]() |
Remove the nut and separate the stabilizer link from the shock absorber.
| 10. SEPARATE FRONT SUSPENSION LOWER ARM |
![]() |
Remove the clip and castle nut.
![]() |
Install SST (spacer B) to the threaded section of the lower ball joint.
Using SST, separate the front lower suspension arm from the front axle assembly.

| 11. SEPARATE FRONT AXLE ASSEMBLY |
Using a plastic hammer, tap the end of the drive shaft and disengage the fitting between the drive shaft and front axle.
Push the front axle out of the vehicle to remove the drive shaft from the front axle.
| 12. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH |
![]() |
Using SST, remove the drive shaft.
| 13. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH |
![]() |
Using a screwdriver and hammer, remove the drive shaft.
| 14. FIX FRONT AXLE ASSEMBLY |
![]() |