Home › ENGINE · 1NZ-FE › COOLING › COOLING FAN RELAY

COOLING FAN RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT COOLING FAN RELAY NO. 2


A030519
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      3 - 4
      Below 1 Ω
      3 - 4
      10 kΩ or higher (when battery voltage applied to terminals 1 and 2)
      3 - 5
      10 kΩ or higher
      3 - 5
      Below 1 Ω (when battery voltage applied to terminals 1 and 2)

      If the result is not as specified, replace the relay.