POWER WINDOW REGULATOR MOTOR (for Hatchback Rear Side) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the rear door armrest plug.
![]() |
Remove the 2 screws.
![]() |
Disengage the 7 clips.
Disconnect the connector.
![]() |
Disconnect the rear door lock remote control cable and rear door inside locking cable and remove the rear door trim board.
| 3. REMOVE REAR DOOR SERVICE HOLE COVER |
![]() |
w/ Rear speaker:
Disconnect the connectors and clamps, then remove the rear door service hole cover.
![]() |
w/o Rear speaker:
Disconnect the connectors and clamps, then remove the rear door service hole cover.
| 4. REMOVE REAR DOOR CHECK ASSEMBLY |
![]() |
Remove the 3 bolts, then remove the rear door check.
| 5. REMOVE REAR DOOR WEATHERSTRIP |
![]() |
Disengage the 32 clips and remove the rear door weatherstrip.
| 6. REMOVE REAR DOOR BELT MOULDING |
![]() |
Apply protective tape to the door panel in the area around the rear door belt moulding.
![]() |
Using a moulding remover, disengage the 5 claws and the clip and remove the rear door belt moulding.
| 7. REMOVE REAR DOOR GLASS RUN |
![]() |
Remove the rear door glass run.
| 8. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY |
![]() |
Remove the 2 bolts and screw and rear door window division bar.
| 9. REMOVE REAR DOOR QUARTER WINDOW WEATHERSTRIP |
![]() |
Slide the rear door quarter window weatherstrip, in the direction indicated by the arrow in the illustration, to remove it.
Remove the rear door quarter window glass from the rear door quarter window weatherstrip.
| 10. REMOVE REAR DOOR GLASS SUB-ASSEMBLY |
![]() |
Remove the rear door glass from the rear door window regulator.
| 11. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY |
![]() |
Disconnect the connector.
Loosen bolt A.
Remove the 3 bolts, then remove the rear door window regulator.
| 12. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY REAR |
![]() |
Using "Torx" socket wrench T25, remove the 3 screws and the power window regulator motor.