Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › DRIVER SIDE KNEE AIRBAG ASSEMBLY (for Hatchback)

DRIVER SIDE KNEE AIRBAG ASSEMBLY (for Hatchback) > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE STEERING COLUMN COVER


C118007
  1. Turn the steering wheel 90 degrees in both directions and remove the 2 screws.

  1. Remove the screw from the lower portion of the steering cover lower.

  1. Disengage the 2 claws and remove the steering column cover lower.



3. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY LH


    B114572
  1. Remove the 2 screws.

  1. Disengage the 3 claws and remove the instrument panel under cover.



4. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY


C119072E01
  1. Remove the 4 bolts.

  1. Disengage the 6 claws and remove the driver side knee airbag assembly.

  1. Using a thin-bladed screwdriver, release the locking button.

  1. Using a thin-bladed screwdriver, disconnect the airbag connector and remove the instrument panel wire.