Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SIDE AIRBAG SENSOR (for Hatchback 5 Door)

SIDE AIRBAG SENSOR (for Hatchback 5 Door) > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT DOOR SCUFF PLATE RH


    B114284
  1. Disengage the 8 claws and remove the front door scuff plate.



3. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH


B114286
  1. Remove the front door opening trim weatherstrip to the extent necessary to remove the center pillar garnish.



4. REMOVE REAR DOOR SCUFF PLATE RH


    B114287
  1. Disengage the 6 claws and remove the rear door scuff plate.



5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH


B114288
  1. Remove the rear door opening trim weatherstrip to the extent necessary to remove the center pillar garnish.



6. REMOVE CENTER PILLAR LOWER GARNISH RH


7. REMOVE SIDE AIRBAG SENSOR ASSEMBLY

CAUTION:
Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.



    B106572E01
  1. Slide the outer housing and detach the airbag connector.



    B106573E01
  1. Remove the bolt, disengage the hook and remove the side airbag sensor.