Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG CUT-OFF SWITCH (for Hatchback)

AIRBAG CUT-OFF SWITCH (for Hatchback) > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


B108202
  1. Slightly deform the upper part of the glove compartment door assembly to release the 2 stoppers and open the glove compartment door assembly until it becomes horizontal.



    B105351
  1. Pull the glove compartment door assembly out horizontally to disengage the hinge portion and remove the glove compartment door assembly.

    NOTICE:
    Pull the glove compartment door out horizontally, otherwise, installation failure caused by excessive play around the hinge portion will result.



3. REMOVE AIRBAG CUT-OFF SWITCH


B212380
  1. Disconnect the airbag cut-off switch connector.

  1. Remove the instrument panel lower while holding the 2 claws of the airbag cut-off switch.