DTC P0741 Torque Converter Clutch Solenoid Performance (Shift Solenoid Valve SL) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0741 | (a) Lock-up does not occur when driving in lock-up range or lock-up remains ON in lock-up OFF range. (2-trip detection logic) (b) When lock-up is ON, clutch or brake slippage occurs or gear breaks. (2-trip detection logic) |
|
| ACTIVE TEST |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn on the tester
Select the following items: Powertrain / Engine and ECT / Active Test / Control the Lock Up.
In accordance with the display on the tester, perform the Active Test.
| Item | Test Details | Diagnostic Note |
| Control the Lock Up | [Test Details] Control the shift solenoid SL to set automatic transaxle to lock-up condition. [Vehicle Condition] Vehicle Speed: 60 km/h (36 mph) or more, and 4th gear | Possible to check SL operation. |
Lightly depress the accelerator pedal and check that the engine speed does not change abruptly.

| 1.CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0741) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn on the tester.
Select the following items: Powertrain / Engine and ECT / DTC / Current or Pending.
Read the DTCs using the tester.
| Display (DTC output) | Proceed to |
| P0741 | A |
| P0741 and other DTCs | B |
|
| ||||
| A | |
| 2.INSPECT SHIFT SOLENOID VALVE SL |
![]() |
Remove shift solenoid valve SL.
Measure the resistance.
| Tester Connection | Specified Condition |
| Solenoid Connector (SL) - Solenoid Body (SL) | 11 to 15 Ωat 20°C (68°F) |
Connect the positive (+) lead to the terminal of the solenoid connector and the negative (-) lead to the solenoid body to check the solenoid valve operation.
|
| ||||
| OK | |
| 3.INSPECT TRANSMISSION VALVE BODY ASSEMBLY |
|
| ||||
| OK | |
| 4.INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY |
|
| ||||
| OK | ||
| ||